Faults & repairs · Strood, ME2
LVT tiles curling at the corners in Strood? Usually a bond fault, sometimes moisture. We test before recommending any repair.
A hollow sound underfoot on LVT in Strood doesn't always mean the floor looks wrong yet. Bond failure can spread under the surface before it shows visually, which is why a tap test across the whole room tells us more than just looking at the obvious spot.
Because Strood includes riverside developments and victorian terraces, the same symptom can have two very different causes. Diagnosis comes before any quote to replace.
Bubbling vinyl in kitchens around Wainscott is usually adhesive failure from trapped moisture rather than the sheet material breaking down.
Faults reported from units near Wainscott after a fit-out change frequently trace back to services run under the floor without adequate protection.
A repair is only as good as the surface it's stuck to. If the original subfloor wasn't properly primed, levelled or dried before the first fit, the same conditions that caused the lift will usually cause it again unless they're corrected as part of the repair.
We treat subfloor preparation as part of the repair scope, not an optional extra, particularly where moisture or an uneven surface has been identified.
Resolve any leak, DPM gap or damp cause before sealing the floor back down.
Allow adequate drying time and re-test before any adhesive is applied.
Correct any surface issue contributing to the original bond failure.
Our own photographs, used to show construction detail and finish. They are illustrative rather than tied to a specific property.
Even a good colour match can show a faint seam line once light hits the floor at an angle, because LVT wear layers dull slightly with age and cleaning products over time. We'll always flag this possibility before starting a patch repair rather than let it come as a surprise.
Where the visible seam matters, for example a hallway or shopfront in {town}, replacing a full run of planks rather than a single tile usually gives a cleaner result even though it's more material.
We reach Strood via the A228, and cover the wider ME2 district as part of our normal round.
Postcode district ME2, Medway Council.
Click LVT lifting is usually an expansion gap problem since there's no adhesive involved, while glue-down LVT lifting is usually a bond or moisture problem at the adhesive layer.
Yes, a slow leak can sit under sealed LVT for some time before enough moisture reaches the bond line to cause visible lifting, which is why sudden lifting near a wet area always gets a moisture check.
Yes, we regularly survey and repair LVT we didn't originally fit, and the same diagnosis process applies regardless of who installed it.
It depends on the flooring manufacturer's specified limit and the adhesive being used, but readings consistently above the accepted threshold usually mean the moisture source needs resolving before any repair is bonded down.
A hollow sound underfoot is worth checking in Strood properties before it becomes visible lifting, since early diagnosis usually means a smaller repair.
We test the subfloor and bond before recommending any repair work.